Начал использовать робота и столкнулся с двумя неприятными проблемами. Хотелось бы знать это баги или так и надо:
1. Робот не летает выше 7-и блоков. Когда под роботом 7 блоков пустоты он может ехать только вниз.
2. Мой робот не ломает блоки в моём привате. Это потеря потерь.
Роботы OpenComputers
Re: Роботы OpenComputers
Как всегда спасибо за оперативность. А летать он будет после регистрации?!
Re: Роботы OpenComputers
Должен, хотя не уверен. Но копать в привате точно будет.
Re: Роботы OpenComputers
В продолжение предыдущего разговора... Черепахи не летают выше высоты 8 блоков. Это довольно неудобно для геолого-разведывательных работ в майнинге. Нашёл строчку в конфиге OpenComputers, которая ха это отвечает. Предлагаю её исправить.
# Limit robot flight height, based on the following rules:
# - Robots may only move if the start or target position is valid (e.g.
# to allow building bridges).
# - The position below a robot is always valid (can always move down).
# - Positions up to <flightHeight> above a block are valid (limited
# flight capabilities).
# - Any position that has an adjacent block with a solid face towards the
# position is valid (robots can "climb").
# Set this to 256 to allow robots to fly whereever, as was the case
# before the 1.5 update. Consider using drones for cases where you need
# unlimited flight capabilities instead!
limitFlightHeight=8
# Limit robot flight height, based on the following rules:
# - Robots may only move if the start or target position is valid (e.g.
# to allow building bridges).
# - The position below a robot is always valid (can always move down).
# - Positions up to <flightHeight> above a block are valid (limited
# flight capabilities).
# - Any position that has an adjacent block with a solid face towards the
# position is valid (robots can "climb").
# Set this to 256 to allow robots to fly whereever, as was the case
# before the 1.5 update. Consider using drones for cases where you need
# unlimited flight capabilities instead!
limitFlightHeight=8
Re: Роботы OpenComputers
Высоту исправил, поднял до высоты мира теперь должно быть нормально. Тема закрыта.
Кто сейчас на конференции
Сейчас этот форум просматривают: нет зарегистрированных пользователей и 5 гостей